My Lab results show I have a small mesh called MMN and have 13 nodes 8 are shown.  Prior to deploying my mesh nodes I test them out and various scenario to ensure that everything is working.  They use to call it "Burn Test" in the 80's.

I setup a channel 1 and channel 8.  Nodes O-lab 20040601- and D-Experimental are on dev 94.

Wiana reporter that Channel 1 is Meshing with Channel 8. I've checked reporter on O-Lab and sure enough I can see channel 8 on D-Experimental  .  What I think is happening is either the topology graph is screwing up or something has been implemented that has made the units gone astray.  

I did not investigate it any further.  If you can duplicate this scenario please let me know.

I will reset the lab back to dev 88.