Wind Vibration and Prototypes

Well you think that you have seen everything and then something new appears. I had one of my units go down. No signal no nothing. It was accessible and went to see what had happen. I was told that the wind start to vibrate the enclosurer. The vibration shook the unit and a few items can disconnected, i.e. ethernet CAT 5 cable and the radio card. Now here is the funny thing. Both these items clip into either ethernet port or mpci port. Both clips failed. It looks like I have to glue down or remount these clips. The problem with gluing the mounts are that they will not be interchangeable if failure occurs. If I use a mechanical clamp that mean additional cost. There has to be a better solution out there?